Maintenance and maintenance of automobile inspection tools

by:Top Talent     2020-06-24
Nowadays, with the increasing accuracy and design requirements of automobile inspection tools. Many vehicle inspection tools require more adequate maintenance to extend their service life. The following is a brief introduction to the basic steps and methods of car inspection tool maintenance: ????1. Ensure the environmental factors of the car inspection tool are dry: the storage temperature is guaranteed to be between minus 10 degrees Celsius and 60 degrees Celsius; the humidity must be below 60%; the particles cannot exceed 2%. ????2. Basic maintenance of vehicle inspection jigs: ensure that the exterior of the inspection jig simulation block is clean, and some plugs, detection pins, bottom plates, etc. must be kept clean; place the moving parts that need to be disassembled at the corresponding positions. ????3. Maintenance time can be handled in half a year or once a year: ????(1) Check whether the bolt hole is worn, and replace it if there is any problem; ????(2) Check the precision slideway for looseness, add lubricating oil; ????(3) Check whether the positioning reference is worn and rust-proof, and some may be replaced or polished in time; ????(4) Check the marking scale and coating for wear and tear in time. Maintenance according to the above methods can basically ensure that your car inspection products will not have too many problems. Good maintenance can ensure the accuracy of car inspection tools and promote the improvement of work efficiency.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...