Fixture automation is safe and economical

by:Top Talent     2020-05-16
Technology is based on the former productivity. Now, as long as the conditions are suitable, most industrial production will move closer to the direction of automated production, making production and processing more convenient. Automatic hydraulic fixture There are also requirements in this regard for fixtures, especially in the occasions where fast mold change is required, so there is an economical product choice between mechanical fixtures and magnetic templates: automatic hydraulic fixtures, which have low initial investment and are suitable for wide range. Automatic hydraulic fixtures can replace manual fixtures, without the need to modify the machine (* please refer to the remarks below), automatic clamping, save labor, safer and more economical. When working, the chuck can slide in the T-slot (usually left and right clamping). After the mold is loaded into the mold in place, the chuck can be controlled to clamp the mold by manual operation. The clamping time for a single die change is reduced from 50 minutes to 5 minutes. Assuming that the die is changed 3 times a day, 60 to 70 hours a month can be saved, which greatly improves the production efficiency. Of course, to enjoy the above advantages also has its requirements: it must be equipped with a T-slot (no T-slot or T-slot is not standard and cannot be used); the mold must be an I-shaped mold, and the thickness of the mold backplane must be standardized (length x width x thickness Must be unified to one size).
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...